Log in to post
|
Print Thread |
|
|
|
|
PowerTracks Pro Audio
|
Joined: Dec 2006
Posts: 587
Journeyman
|
OP
Journeyman
Joined: Dec 2006
Posts: 587 |
A little while back I started to noticed while using headphones, tracks were dropping out and an overall decrease in volume in PT 2017. I noticed when I pulled the jack out slightly in my audio I/O device (Line 6 Pod Studio UX1 , where the headphones are plugged in) I could hear them again, but overall still decreased volume. I replaced all cables and the headphone cable. I also replaced my I/O device, thinking maybe the input jack for the headphones was wearing out. Same issue! When I close PT, and listen to other music, everything is fine! That was yesterday. Today, launched PT and everything is fine! Anybody out there have ANY idea what is going on? Thanks as always, Bernie
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: May 2000
Posts: 21,609
Veteran
|
Veteran
Joined: May 2000
Posts: 21,609 |
If it happens again, open the Mixer and look at 2 sliders.
One is labeled A1 in the bottom right section. Push it up, have a good signal going out here. The other lies between the Tracks side of the Mixer and the AUX/MainOut side, It's a lonely slider, out there on it's own, I think it's even unlabeled. Not sure why it is there, but it does affect the output.
Make your sound your own! .. I do not work here, but the benefits are still awesome
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Dec 2006
Posts: 587
Journeyman
|
OP
Journeyman
Joined: Dec 2006
Posts: 587 |
I think the unlabeled mixer you are talking about is the main that controls all the others at once, unless I'm looking in the wrong place. Interestingly today, I had the sMe problems. Also, when I closed all of my apps and just opened a movie on the internet, same issue - extremely low volume!
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: May 2000
Posts: 21,609
Veteran
|
Veteran
Joined: May 2000
Posts: 21,609 |
Also, when I closed all of my apps and just opened a movie on the internet, same issue - extremely low volume! Yeah, that sounds like it isn't a PT issue. More likely a Windows setting.
Make your sound your own! .. I do not work here, but the benefits are still awesome
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Dec 2006
Posts: 587
Journeyman
|
OP
Journeyman
Joined: Dec 2006
Posts: 587 |
I have noticed when I am playing a PT file only certain tracks play. Also, when listening to music or movies, only part of the audio is present. Not sure where even to begin on this one. Any suggestions? Thanks!
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Dec 2016
Posts: 1,169
Expert
|
Expert
Joined: Dec 2016
Posts: 1,169 |
There have been many discussions on issues with audio particularly after Windows updates. Have you looked at them? Maybe the answer is there. For example the post Re: Sound gone wonky since windows update. However to me what you describe almost sounds as if it is hardware and you a losing a channel.
Tony
HP i7-4770 16GB 1TB SSD, Win 10 Home, Focusrite 2i2 3rd Gen, Launchkey 61, Maton CW80, Telecaster, Ovation Elite TX, Yamaha Pacifica 612 BB 2022(912) RB 2022(2), CakeWalk, Reaper 6, Audacity, Melodyne 5 Editor, Izotope Music Production Suite 4.1
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Dec 2006
Posts: 587
Journeyman
|
OP
Journeyman
Joined: Dec 2006
Posts: 587 |
Last resort - totally restoring my system to factory image. The I'm going to reinstall everything for music step by step and see what happens. It's a good thing my system is almost new and there is nothing on it but software for making music!
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Dec 2006
Posts: 587
Journeyman
|
OP
Journeyman
Joined: Dec 2006
Posts: 587 |
Reimaged my system reloaded everything, all seems to be fine now. Not sure what the issue is, I just hope I never see it again! Thanks all for your help! Bernie
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Dec 2006
Posts: 587
Journeyman
|
OP
Journeyman
Joined: Dec 2006
Posts: 587 |
The gremlin has returned after a couple days. Losing bass and overall volume. Did a system restore and no help. Talked to Dell and they think it may be a hardware problem. Shipping the CPU back to Dell. And the saga continues...
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Aug 2011
Posts: 10,099
Veteran
|
Veteran
Joined: Aug 2011
Posts: 10,099 |
Bernier,
Thanks for the continuing the updates. Most forum responses agree the issue is hardware related. So everyone is eager to know what Dell finds out.
Jim Fogle - 2024 BiaB (1109) RB (Build 3) Ultra+ PAK Cakewalk - Zoom MRS-8 recorder Desktop: i7 Win 10 build 2004, 12GB ram 256GB SSD, 4 TB HDD Laptop: i3 64bit Win 10 build 21H2, 8GB ram 500GB HDD Music at: https://fogle622.wix.com/fogle622-audio-home
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Dec 2006
Posts: 587
Journeyman
|
OP
Journeyman
Joined: Dec 2006
Posts: 587 |
Update - I tried my headphones with my iPad and had the same problem as my music PC so it is not the PC. I noticed when I jiggled the headphone end of the Jack the problem disappeared. This is what I have suspected from the beginning. I actually had my headphones and associated cable replaced, and had the same problem.. I think it is a design issue in the headphones. Since the headphone cable has a microphone built in the cable, I thought that might be the issue because the Jack for my audio I/O (Line 6 UX1) probably dos not utilize this. I normally plug my headphones into the UX1. My PC is capable of Bluetooth and my headphones are also wireless Bluetooth capable. When I look for audio devices in my PC it lists the Line 6 UX 1 as my sound card. Since UX1 is plugged into my PC via usb, now I am wondering if my playback will be routed through the UX1 sound card and delivered wirelessly to my headphones. That would eliminate the cable issue. Gonna give it a try.....
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: May 2000
Posts: 21,609
Veteran
|
Veteran
Joined: May 2000
Posts: 21,609 |
Yeah, I'm guessing it might work, but not how you are thinking it does.
I think the signal will be routing from the computer to the headphones directly. At that point the UX1 is no longer in the signal path between PT and the headphones. It then becomes a Windows routing issue.
Make your sound your own! .. I do not work here, but the benefits are still awesome
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Jan 2006
Posts: 337
Journeyman
|
Journeyman
Joined: Jan 2006
Posts: 337 |
Headphone jacks are no longer all created equally. The fact that 3mm/eighth-inch headphone jacks have gradually become non-standard is one of the dirty little secrets of globalization and marketing focusing on cell phones rather than dedicated audio devices. Consumers more readily accept this crappy treatment than do professionals, which might explain why 1/4-inch jacks don't have nearly the same incompatibility issues.
Paj 8^)
|
|
|
|
|
|
|
|
|
|
|
|
PowerTracks Pro Audio
|
Joined: Dec 2006
Posts: 587
Journeyman
|
OP
Journeyman
Joined: Dec 2006
Posts: 587 |
Thanks for the response. I agree - it has shown itself to be a headphone jack issue. Do you know where I can get a good replacement? Thanks! Bernie
|
|
|
|
|
|
|
|
|
|
|
|
Ask sales and support questions about Band-in-a-Box using natural language.
ChatPG's knowledge base includes the full Band-in-a-Box User Manual and sales information from the website.
|
|
|
|
|
|
|
|
|
|
|
Convenient Ways to Listen to Band-in-a-Box® Songs Created by Program Users!
The User Showcase Forum is an excellent place to share your Band-in-a-Box® songs and listen to songs other program users are creating!
There are other places you can listen to these songs too! Visit our User Showcase page to sort by genre, artist (forum name), song title, and date - each listing will direct you to the forum post for that song.
If you'd rather listen to these songs in one place, head to our Band-in-a-Box® Radio, where you'll have the option to select the genre playlist for your listening pleasure. This page has SoundCloud built in, so it won't redirect you. We've also added the link to the Artists SoundCloud page here, and a link to their forum post.
We hope you find some inspiration from this amazing collection of User Showcase Songs!
Congratulations to the 2023 User Showcase Award Winners!
We've just announced the 2023 User Showcase Award Winners!
There are 45 winners, each receiving a Band-in-a-Box 2024 UltraPAK! Read the official announcement to see if you've won.
Our User Showcase Forum receives more than 50 posts per day, with people sharing their Band-in-a-Box songs and providing feedback for other songs posted.
Thank you to everyone who has contributed!
Video: Volume Automation in Band-in-a-Box® 2024 for Windows®
Video: Audio Input Monitoring with Band-in-a-Box® 2024 for Windows®
Video: Enhanced Melodists in Band-in-a-Box® 2024 for Windows®!
We've enhanced the Melodists feature included in Band-in-a-Box® 2024 for Windows!
Access the Melodist feature by pressing F7 in the program to open the new MultiPicker Library and locate the [Melodist] tab.
You can now generate a melody on any track in the program - very handy! Plus, you select how much of the melody you want generated - specify a range, or apply it to the whole track.
See the Melodist in action with our video, Band-in-a-Box® 2024: The Melodist Window.
Learn even more about the enhancements to the Melodist feature in Band-in-a-Box® 2024 for Windows at www.pgmusic.com/manuals/bbw2024upgrade/chapter3.htm#enhanced-melodist
Band-in-a-Box® 2024 DAW Plugin Version 6: New Features Specifically for Reaper®
New with the DAW Plugin Version 6.0, released with Band-in-a-Box® 2024 for Windows: the Reaper® Panel!
This new panel offers built-in specific support for the Reaper® DAW API allowing direct transfer of Band-in-a-Box® files to/from Reaper® tracks!
When you run the Plugin from Reaper®, there is a panel to set the following options:
-BB Track(s) to send: This allows you to select the Plugin tracks that will be sent Reaper.
-Destination Reaper Track: This lets you select the destination Reaper track to receive media content from the Plugin.
-At Bar: You can select a bar in Reaper where the Plugin tracks should be placed.
-Start Below Selected Track: This allows you to place the Plugin tracks below the destination Reaper track.
-Overwrite Reaper Track: You can overwrite previous content on the destination Reaper track.
-Move to Project Folder: With this option, you can move the Plugin tracks to the Reaper project folder.
-Send Reaper Instructions Enable this option to send the Reaper Instructions instead of rendering audio tracks, which is faster.
-Render Audio & Instructions: Enable this option to generate audio files and the Reaper instructions.
-Send Tracks After Generating: This allows the Plugin to automatically send tracks to Reaper after generating.
-Send Audio for MIDI Track: Enable this option to send rendered audio for MIDI tracks.
-Send RealCharts with Audio: If this option is enabled, Enable this option to send RealCharts with audio.
Check out this video highlighting the new Reaper®-specific features: Band-in-a-Box® DAW Plugin Version 6: New Features Specifically for Reaper®
Band-in-a-Box® 2024 DAW Plugin Version 6: New Features Video
|
|
|
|
|
|
|
|
|
|
|
Forums66
Topics81,396
Posts732,505
Members38,442
|
Most Online2,537 Jan 19th, 2020
|
|
|
|
|
|
|
|
|