I just bought a Roland VSC3 ver 3.2 cd. I was able to install easilly, however it doesn't work. When I try to open it I get a message "VSC midi device cannot be opened. It shows up as a midi device on power tracks, but when I highlight it it says driver was not enabled. I don't see any folders on the disk specific for drivers. I have changed setting for midi in the control panel, still nothing. Anyone have any suggestions? I using Windows XP Professional ver 2002 service pack 3

I hope you didn't pay too much for it. The VSC3 hasn't worked in a very long time. It's why PGMusic replaced it with the CoyoteWT. It used to ship with BIAB.

As I recall, however, it worked (but with errors) in WinXP 32-bit, so I would try maybe seeing if it runs in a compatibility mode (maybe select Windows 98 or 95).