If you have a 1010lt you have a lot of possible signal routing options when you include the mixer in that sound card.

Do you have input in the 1010's separate mixer?

If so it is likely the input driver selection in PT.
The image below shows how my 1010LT Mixer looks. Note there are separate Input and Output tabs that can complicate things.

Make sure that mixer has signal as expected.

If you do, go to Prefs-Options-Audio then click the Drivers button and make sure you have the desired inputs highlighted.
After selecting these (if using MME), use the Move Selected to Top button, so they become the used inputs.

The second image shows how the ASIO drivers appear in PT for me. The 1010 can use either - MME or ASIO, the MME screen just looks a tiny bit different than my image.
/Ignore the arrows in the image - I re-purposed an image I used in a previous post. The arrows mean nothing in your situation.

At least that's where I'd start.

Attached Files (Click to download or enlarge) (Only available when you are logged in)
1010Mixer.jpg (92.72 KB, 50 downloads)
1010Asio.jpg (92.12 KB, 46 downloads)
Last edited by rharv; 02/02/18 02:17 PM.

Make your sound your own!
.. I do not work here, but the benefits are still awesome