<raises hand>
Did you ever try recording with all available input drivers enabled? I know you have said M-Audio 1/2 is your only choice, but since you are running windows I would think that the MS Soundmapper would still show up (unless you specifically uninstalled it which would be difficult) especially when using MME.

So have you tried recording every available port at once just as a test yet? Whether you call them drivers or devices it is an important setup step to find the correct one. Windows has been known to mix/match devices via drivers before. Hence my post about incorrect labeling of drivers(devices) earlier. RB uses the driver to select which input device it is recording.

I'll look back (again) to see if I missed results for this.
/sorry for the 'driver' talk, but in RB drivers point to devices so it is the most relevant solution. Your device is not recording after all.

Last edited by rharv; 08/02/11 01:20 PM.
Make your sound your own!
.. I do not work here, but the benefits are still awesome