Dave,

Try the below and see if it helps.

Firstly...

Have a look at IMAGE 1 below.

1. Click on Audio (#1 on IMAGE 1)

2. Select "Audio | Audio Driver/Settings" (#2)

3. Click on the dropdown menu (#3) and set the Audio driver to MME (it's probably set to WAS at the moment)


Secondly...

Have a look at IMAGE 2 below.

1. Select "Options | Preferences" and then select the MIDI driver button (#1 on IMAGE 2)

2. Set #2, #3, #4, #5 exactly as shown on IMAGE 2

3. Click on button #6. This will open a new dialogue window (IMAGE 3 below).

4. Click on "Default Synth" button (#1 on IMAGE 3)

5. Click on the dropdown menu (#2) and select Coyote WT. Close the window

6. Button #7 should say MME. If it doesn't, click on it and select MME as the audio driver

The above are general, default settings for BIAB that should work.



Now Exit back to BIAB.

Load a song, generate it and see how it sounds. I suggest that before trying a song that's a mix of MIDI tracks, Realtracks and Realdrums, try a song that is all Realtrack and Realdrums.

How did you go? Did the all-Realinstruments song play ok? Also, did the song that was a mix of MIDI and Realtracks play ok?


Regards,
Noel

Attached Files (Click to download or enlarge) (Only available when you are logged in)
audio driver set up audio menu.JPG (56.03 KB, 66 downloads)
IMAGE 1... Audio driver settings in the 'Audio' menu
coyote WT and audio settings.JPG (119.08 KB, 66 downloads)
IMAGE 2... MIDI driver and VSTi/DXi basic setup
coyote WT setting as default synth.JPG (43.2 KB, 64 downloads)
IMAGE 3... Setting Coyote WT as the default synth
MY SONGS...
Audiophile BIAB 2024