Bob,

The latest sad story...

I followed the "Screen shots" included in the V. 4 (GM Mode) User's Guide (page 3). If things are not intuitive I bounce off them. I found the screen on my Kurz, pressed the GM soft button to call up the GM page, and when I saw that GM was off (unlike the second "screen shot" on page 3, I turned it to "ON."

Just below where I switched it to on it says in the "screen shot":

GM Studio : 500 GM1 Room.

Mine says: 500 Not Found

In fact, scrolling through it none of the 500 - 505 Rooms or Halls, etc. mentioned on page 3 could be found.

Then I went to the Master2 GM screen (on the bottom of page 3), and since mine said the same thing, I left it as is.

BIG PROBLEM: When I got though with this nothing seemed to have changed with BIAB. However, when I went back to program mode to access my instruments (800 - 900 of them), I was at 400 and it said: 400 Not Found. Worse than that, all the instruments from 199 (just above 400 now) through 730 are missing. BTW, all this stuff was already loaded on my Kurz when I bought it used.

I would just like to get back to where I used to be (Didn't Merle Haggard write that or something like that?).

I am deathly afraid of hitting any RESET buttons on the Kurz. Do you have any ideas about this.

Jerry

P.S. Thanks for sticking with me this long.

Last edited by natcheztoo; 06/22/11 12:20 PM.