Thanks Everybody. The dual melody issue cause was as you said.

The woodblock channel was set to 0

Here's the channel settings now:

Bass 2
Piano 3
Melody 4
Strings 6
Guitar 7
Midi drums 10 (but Real drums are used)
Woodblock 11

Now I'm not getting any sound for the bass, piano, and melody. The sound is going into the SD2 though since the light is blinking. However, it blinks fine for the strings, guitar and woodblock, too. This is freaking me out.

Update: I tried to change all of the channel numbers to be the same as the track numbers. All worked okay except for the guitar track which I had changed to channel 4. No audio. So I went to the Events List and put in a control change to channel 4. That didn't work either. Since everything in the events list showed channel 7, I just changed it to that. Channel 4 just didn't want to work on this song. I did check another midi song and all the channels on it worked fine. Bottom Line....Only the great Midi God knows for sure..

Thanks to all for helping out the old curmudgeon.

Last edited by Shastastan; 04/21/12 06:01 PM.
Cornet Curmudgeon