Quote:

Quote:

BTW - my VFX-SD took a dump back in February. It's probably repairable, but right now I'm saving for a Casio XW-P1.




You have any idea WHAT is bad on it? I have a dead one as well. If you could Frankenstein one good one out of the 2 I would give it to you. I have NO clue what is wrong. It won't boot and a hard reset did nothing. The only good guy I know of that fixes Ensoniq gear is in Philadelphia, but by the time I would send it there and he would send it back, the shipping alone would make it way short economically wise. I also factor in that cheapskate factor. In fact, I am so tight I squeak.....




I have yet to crack the top open. I'm guessing is the joint between the two main PCBs. That was a common failure on those boards - the edge connector they used didn't cut it - so the repair was to hard wire/solder across every 1-1 connection in the edge connector. I'm guessing one of those went bad. Problem description is that the LED display gets one VERY bright character and the rest are blank.

-Scott