Hi Alan

Good that has saved you a lot of work which tends to send other people round the bend when the copper wire breaks just as your 3/4 through the coil, i have just fished out how to measure the fret positions,

Measure the scale length( middle of top nut or where the strings touch to where the strings go across the bridge) and divide this by 17.835 this gives the distance away from the nut for the first fret , deduct the first anwser from the remaining length and divide this once again by 17,835 this operation is performed throughout for the remaining frets

so if the scale length was say 23 inches devide by 17,835 which would be 2 inches this is taken away from the 23 which leaves 21 inch which is devided by 17,835 which would leave the next fret 1.7/8th and so on the frets getting smaller with each calcurlation( these are not real sizes)

if theres anything you don`t understand just ask

best wishes Dave

Last edited by jazzband; 03/19/09 08:50 AM.
I always play the right notes but not always in the right order