Sep, Assuming that you are using RealTracks I would suggest this as a starting point. A three chorus song of 32 bars each is typical. Not wanting a Soloist to play the complete chorus would go something like this. With the chords entered, select a style, right click on Soloist, this will bring up the Soloist picker. Make your choice and click regenerate. Right click bar #1 and choose bar setting from the list. Select chorus[#1], next mute the Soloist, then right click (same as F5) on bar 17, chorus[#1], click Soloist-back to normal. right click bar 28, in bar settings-[chorus #1], fade Soloist 7 percent. Right click bar one. This is different. In bar settings-select chorus [#2], then click the small RealTracks box. Make your selection and check ok. Click a bar and choose chorus [#2] again to-fade this where ever/change by +or- percent per bar/mute etc. Finally (wheeeew), right click bar one or 10 or what ever. Choose chorus [#3]. Then in bar settings, repeat the procedure outlined for bar #2. This may not be the correct way, but it is my way. I hope it at least points you in the general direction. Or you can open to one long chorus and skip all of the chorus this and that smile -----Leon