A few last comments from my testing of SampleTank 3 on a live project.

LoopB30 was installed to allow the ST3 to operate in a Standalone mode. Initially I was confused by the way in which operational and muted drivers were displayed - see other post.

Jbridge was installed to provide the 32 bit version of the ST3 64bit plugin. This works OK but takes up even more real estate in display. However, I played around with the JBridge Settings and found that you can get the plugin to open in two parts. One part contains the PGMusic headings for adding effects plus the Jbridge Settings. When this part is minimised, the ST3 GUI is displayed on it's own thereby reducing the overall display area required by one third.

I have found that the ST3 Midi Learn function works in the Standalone version only. If you use the Proforma idea with the frequently used Midi Learn entries incorporated then this should not cause a large problem. All other editing parameters can be reset in the Plugin verson. Of course this could be a local problem for me only.

I see that there are a number of training videos available from IMK



Have fun,