Originally Posted By: Islansoul
Before buying a new cable make sure to do the following:

1. Check to make sure that you have assigned the correct audio device to Garage Band that you want to use to connect your synth to. If you have an audio interface, which I assume you do, make sure that you have made that interface as the audio device that you will be recording through.

I've no idea where to find this. I've gone into GB Preferences and can't find anything referring to this, assuming it would be in the Audio/MIDI setup tab?

2. Check to make sure that you have the routing properly setup up. Make shure that the input in Garage band is assigned the input to the correct channel(s) tat you have connected the synth to, and that the output is assigned to the source that audio will come out of.

Only inputs I have showing are: System Setting, Soundflower 2CH, Soundflower 64CH, and Built-In Mic. It also states 2 MIDI inputs detected. A reset button for MIDI does nothing.

3. Make sure that gain from the interface is turned up until is loud enough for you to have a proper recording.

No idea where to find this.


Some men see things as they are and ask "why?"
I dream of things that never were and ask "why not?"