Greetings all.

After dealing with some mental health problems over the past few years (severe depression/anxiety)I finally got the urge the other day to pull out my music stuff and start playing around with it again. It took me forever to figure which wire goes where, finding drivers and all the other stuff that is needed in order to make a little noise. OK... lots of noise.

I've re-installed my old BIAB software (2008.5) and it was like I've never used it before... it was all new to me... again. The plan is to see how much fun I'm having, and then decide if I should be upgrading.

The problem I'm having is with the chord sheet. I am positive that the last time I used it (almost 6 years ago) I was able to type in 4 chords into one bar. I am not able to do this now. It only allows me to type in 2 chords on the first and third beat within that bar. Also, when I'm playing back my song, the bars are completely black as it moves from bar to bar.

I'm pretty sure that there is a setting that I'm missing that will allow me to get it back to normal. I just can't seem to find it. I even got out my BIAB manual to see if I would find something in there, but no luck. I'm hoping that perhaps someone here might be able to point me where to go to change a setting in order to get me up and running again?

So very much obliged!!!

Bobby

Win 7
BIAB/RB version 2008.5