Well Gang,
Back again! LOL
Have another issue with PTPA-11 that I can't seem to find the answer to.
I would also like to invoke input monitoring so I can put some realtime reverb on my vocal as I record and be able to hear the reverb AS I am recording it. However the actual recorded track would prefer it be dry.
I have read several posts on how to do this including the FAQ's as noted below:

Enable Input Monitoring (ASIO Only) – When this checkbox is enabled (and ASIO is selected in the Driver Type combo) then PowerTracks will take the ASIO input signal from input port number 1 and send it to output 1 so that you will hear the input through the speakers. You can apply realtime effects to the monitored input by selected “
Input” in the top combo box of the DirectX/VST Realime Effects dialog. You can then select up to 4 DirectX or VST effects.

WARNING! - Do not enable this feature if the input port number 1 is set to record the output (e.g. “What you hear” or “Mix” )because enabling input monitoring in this case will cause massive feedback that could hurt your ears!

Allow IM Effects Recording – When this is enabled, and Input Monitoring is enabled, and effects plugins are enabled for input monitoring (as described above), the effected signal will be recorded instead of the dry signal.

What I cannot find anywhere in PTPA-11 is the part about:
You can apply realtime effects to the monitored input by selected “
Input” in the top combo box of the DirectX/VST Realime Effects dialog. You can then select up to 4 DirectX or VST effects.
Where do I find the top combo box of the DirectX/VST Realime Effects dialog??
I have tried every window, every menu, every sub-menu, every drop-down box, every pop-up box that I can find in PT-11 and cannot find this "combo box" that is referred to.
What am I missing???

Thanks,
Larry