|
Log in to post
|
Print Thread |
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Jan 2002
Posts: 1,486
Expert
|
OP
Expert
Joined: Jan 2002
Posts: 1,486 |
There are some simple and not generally known settings you can make to get the best possible performance from a computer soundcard and therefore a cleaner and richer sound.
1. Open the Volume Control panel and in the Playback section Mute and Zero all the channels you are not using.
2. In the Recording section Zero all the channels you are not using.
This saves the resources of the computer soundcard for the channel you are using.
Remember the actions you have done above when you use other channels and getting no response.
Brian
Last edited by Jazzman; 09/25/07 07:44 AM.
BIAB - RealBand - 2022
Windows 10 64
Zoo computer with 7i processor- SSD 1TB -2TB HDD
Roland keyboards
|
|
|
|
|
|
|
|
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Jan 2002
Posts: 7,913
Veteran
|
|
Veteran
Joined: Jan 2002
Posts: 7,913 |
This tip will certainly result in a cleaner sound and it's true with any signal chain; whether inputs to your audio card or mixing live sound - if it's not being used; it gets the mute.
When I run live sound, I almost always bus individual channels to subgroups (all vox to a group, drumkit to a group, guitars to a group, etc.) and then use the mute on the groups to manage the overall amount of 'noise-floor' that can get added up.
However, I must say that with most of the live mixing desks I've used in the past few years (Mostly Mackies and Allen & Heaths) the channels are pretty doggoned clean in and of themselves.
Mackie manuals do a nice job leading one through how to get the absolute best gain structure out of their desks - with the first step being to 'zero the board' - doing exactly what you suggest here. On a fresh setup, I'll actually take my hand and start at the right side of the board, and just run it along on the attenuation pots, from right to left, to spin all of the attenuators to zero. That way, even if I forget and leave an unused channel un-muted, it's not on a high-gain setting.
-Scott
Last edited by rockstar_not; 09/25/07 06:09 AM.
|
|
|
|
|
|
|
|
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Jan 2002
Posts: 1,486
Expert
|
|
OP
Expert
Joined: Jan 2002
Posts: 1,486 |
Hi Scott,
Thanks for your comments and I was really refering to computer soundcards.
Brian
BIAB - RealBand - 2022
Windows 10 64
Zoo computer with 7i processor- SSD 1TB -2TB HDD
Roland keyboards
|
|
|
|
|
|
|
|
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Feb 2006
Posts: 1,024
Expert
|
|
Expert
Joined: Feb 2006
Posts: 1,024 |
I got a new SB audigy SE fitted and tried recording a vocal track today - even after doing all of the above muting/zeroing ,I still get a low "buzz".
I can get rid of it with the denoiser, but I'd rather not have it to start with.
(Another thing that happened was that the vocal went out of sync with the backing as the song progressed - I had loaded the Biab tracks into my Magix seq.)
Maybe just "teething" troubles - I hope!
|
|
|
|
|
|
|
|
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Jan 2003
Posts: 5,025
Veteran
|
|
Veteran
Joined: Jan 2003
Posts: 5,025 |
Mark,
Make sure to set the audio tempo when importing the files. Magix has a tendency to decipher the audio and make up its own tempo values.
Trax
|
|
|
|
|
|
|
|
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Jan 2002
Posts: 1,486
Expert
|
|
OP
Expert
Joined: Jan 2002
Posts: 1,486 |
Hi Mark,
That should not happen so double check that on both the Playback and Recording areas again that everything you are not using is either at zero or/and mute.
The mic in and line in cause the most noise here.
Also that all the jack plugs are clean from the grease/sweat of handling with an electrical contact cleaner or spirit wipe.
On the other hand it might be the spec of the SE card which is at the lower end of the range to the top end ZS or X-Fi music cards
I also use Magix amongst others and not had that sync problem - sometimes it is best to re-do.
Brian
Last edited by Jazzman; 09/28/07 03:46 AM.
BIAB - RealBand - 2022
Windows 10 64
Zoo computer with 7i processor- SSD 1TB -2TB HDD
Roland keyboards
|
|
|
|
|
|
|
|
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Feb 2006
Posts: 1,024
Expert
|
|
Expert
Joined: Feb 2006
Posts: 1,024 |
Thanks Brian,
I've checked all the settings - might be the card specs, or the cables as you suggest.
Could there be an "irq" conflict - I think that's what I mean!
|
|
|
|
|
|
|
|
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Jun 2005
Posts: 7,687
Veteran
|
|
Veteran
Joined: Jun 2005
Posts: 7,687 |
Quote:
I got a new SB audigy SE fitted and tried recording a vocal track today - even after doing all of the above muting/zeroing ,I still get a low "buzz".
That noise is almost certainly the mic or cable or both. I would try a different cable first. Make sure it's a proper shielded mic cable. Guitar pickups are known for picking up noise from a CRT monitor if you have one of those. I don't know if a mic will pick up noise from a CRT but try moving away from the monitor anyway. This doesn't sound like a PC/soundcard problem to me but you can also try plugging your PC into another power outlet just for laughs.
Bob
Biab/RB latest build, Win 11 Pro, Ryzen 5 5600 G, 512 Gig SSD, 16 Gigs Ram, Steinberg UR22 MkII, Roland Sonic Cell, Kurzweil PC3, Hammond SK1, Korg PA3XPro, Garritan JABB, Hypercanvas, Sampletank 3, more.
|
|
|
|
|
|
|
|
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Feb 2006
Posts: 1,024
Expert
|
|
Expert
Joined: Feb 2006
Posts: 1,024 |
Thanks Bob,
I think it may be the "out" cable from my Art Studio pre-amp - I was using a cable that has XLR going to a 1/4" jack,and I had an adpter 1/16" on the end going into "line in/mic" on soundcard.
I'm a bit confused about the "balanced" thingy.
Maybe I should just use the 1/4" output from the Art box.
I'll give it a try.
|
|
|
|
|
|
|
|
|
|
|
|
|
Post your own Tips and Tricks here
|
Joined: Feb 2006
Posts: 1,024
Expert
|
|
Expert
Joined: Feb 2006
Posts: 1,024 |
Set up the mic today to do some vocals - checked all the settings etc.
Couldn't get any record imput from my mic.,so I rechecked everything again - mic to pre-amp, cable out from preamp to soundcard(line in) - all plugged in and switched on.
Checked mixer settings - Windows and Audigy - all ok, line in was selected for record and all others muted(except wave playback).
Still no joy. Then I unticked Line in record, and then re-selected it again - hey presto !
Wasted about 1/2 an hour - hope it might help somebody else who might come across this.
Uncheck - Recheck !
|
|
|
|
|
|
|
|
|
|
|
|
Ask sales and support questions about Band-in-a-Box using natural language.
ChatPG's knowledge base includes the full Band-in-a-Box User Manual and sales information from the website.
|
|
|
|
|
|
|
|
|
|
|
User Video: Band-in-a-Box® + ChatGPT = Impressed the BOSS!
Band-in-a-Box User Video Tutorials!
If you've reviewed our Support page, you've probably noticed the Videos page, which separates our Band-in-a-Box® tutorial videos by category: Overview, VST DAW Plugin, Setup, Beginner, Intermediate, Advanced, and there's even an Archive category to go down memory lane... (You'll also find these videos on our YouTube Channel.)
It's always great to hear how other Band-in-a-Box® users create their songs, especially when they explain in detail what they're doing. Like Henry Clarke's YouTube Channel, Henry Clarke - Senior Musicians Unite! There you'll find his ALL Band-in-a-Box Tutorials playlist with over 50 videos! His top-three most watched videos include "How to Get Started with Band-in-a-Box," "How I use the Audio Chord Wizard in Band-in-a-Box," and "How to Create An Effective Solo Using Band-in-a-Box" - however he touches on many other topics and also demonstrates his own Band-in-a-Box® songs in the Band-in-a-Box Created Songs playlist!
You're guaranteed to find some helpful videos when you visit Henry Clarke's channel!
Band-in-a-Box® 2024 Italian for Windows is Here!
Ci siamo dati da fare e abbiamo aggiunto oltre 50 nuove funzionalità e una straordinaria raccolta di nuovi contenuti, tra cui 222 RealTracks, nuovi RealStyles, MIDI SuperTracks, Instrumental Studies, "Songs with Vocals" Artist Performance Sets, Playable RealTracks Set 3, Playable RealDrums Set 2, due nuovi set di "RealDrums Stems", XPro Styles PAK 6, Xtra Styles PAK 17 e altro ancora!
Tutti Pacchetti | Nuove Caratteristiche
Band-in-a-Box® 2024 French for Windows is Here!
Band-in-a-Box® 2024 apporte plus de 50 fonctions nouvelles ainsi qu'une importante de contenus nouveaux à savoir : 222 RealTracks, des RealStyles nouveaux, des SuperTracks MIDI, des Etudes d'Instruments, des Prestations d'Artistes, des "Morceaux avec Choeurs", un Set 3 de Tracks Jouables, un Set 2 de RealDrums Jouables, deux nouveaux Sets de "RealDrums Stems", des Styles XPro PAK 6, des Xtra Styles PAK 17 et bien plus encore!
Tous Packages | Nouvelles Fonctionnalités
Video: Making a Song with Band-in-a-Box®, ChatGPT, and Synth V
Take your Band-in-a-Box® project to a whole new level when you incorporate ChatGPT and Synth V to add lyrics and vocals to your song!
We wanted to demonstrate how this is done with our video, where we show you how to go from nothing to a finished "radio ready" modern pop song by combining the features of Band-in-a-Box®, ChatGPT, and Synth V!
Listen to the finished song, so you get a listen to the finished product: https://demos.pgmusic.com/misc/behindthefame.m4a
If you like it, watch the video. Either way, let's hear your comments!
Henry Clarke: Revolutionize Your Band-in-Box® Tracks with Regenerating Function
User Video: Convert MIDI Chords into AI Vocal Harmonies with ACE Studio and Band-in-a-Box®
|
|
|
|
|
|
|
|
|
|
|
|
Forums65
Topics81,958
Posts739,927
Members38,649
| |
Most Online2,537
Jan 19th, 2020
|
|
|
|
|
|
|
|
|
Dansk
Deutsch - Windows
Español
Français - Windows
Italiano - Windows
Nederlands
Polski
Português
Svenskt
русский
Japanese
Simplified Chinese
Traditional Chinese
Korean