HI

Thanks for your replies
Yes I have seen DAWS that have a gate timing value that you can set the % of all or selected inserted notes value to.
I am sure that the default 80% is fine for most work .it’s just the long tied notes can finish up a bit short.
Many of the voices I use such as sweep pads take a while to develop to their full sweep so I don’t want them cut short , also I tend to use a lot of ambient and evolving
Voices these to need time if I want 3 bars say 12 beats I don’t want to finish up with
Much less like 11 beats and a few ticks.
Still as you say you can always edit the note in the PRV or right click
I do agree the notation entry method in BIAB is very quick and second to none IMO.

But whatever the entry method I do want best part of the value of the notated note.
Some small gap between notes would occur if played live on a keyboard say as you lift off to move to the next note unless you deliberately hold on for a legato effect.
Just my thoughts
Mike


Last edited by Mike Head; 07/11/17 11:29 AM.
BIAB2021 UltraPlus,AsusN55S1Tbssd, W10/64,Akai EIEpro
Yamaha CVP405,SquireStrat, CoolsoftVMidSynth
Novatation Impulse61 Ctr kbd, Cwalk blab Kontakt

http://mikesmusic.byethost16.com/