In Sonar set your theme to Mercury (I say this because it looks different in Tungsten and I’m not used to it but the same rule applies anyhow).

Go to the mixer panel (Console View). Run the song keeping an on both the little symbol next to the post button in the Pro Channel indicator. Assuming you are using the Pro Channel this should say reasonably green. If you are clipping you’ll get a red glow on the clips. Also keep an eye on the figure at the bottom of the volume indicator. It will show you the actual peak level per channel and or the master channel.

Also make sure that your track outputs are going where they should. It is possible for example to be sending a channel directly to the sound card and not via the Master. If such a track is clipping you might not see it in the mix.

Edit: an afterthought also check any hard panning or extra stereo width. For example it is possible to push cymbals out wide where they can really clip and not be noticed in the daw.

Edit: set your theme to Mercury

Just some thoughts

Tony





Last edited by Teunis; 12/30/18 09:30 PM.
HP i7-4770 16GB 1TB SSD, Win 10 Home,
Focusrite 2i2 3rd Gen, Launchkey 61, Maton CW80, Telecaster, Ovation Elite TX, Yamaha Pacifica 612
BB 2022(912) RB 2022(2), CakeWalk, Reaper 6, Audacity, Melodyne 5 Editor, Izotope Music Production Suite 4.1