HI

Try to think of it like this.
Your current setting is correct as the coyote wave table matches the dxi that you are using, and will therefore give you the correct appropriate names for the midi voices

If you was to chose another sound card then the names would reflect that sound card or module .
However as you are using coyote wave table as your dxi you could use any sound card setting that had a generic GM voice set at it would be the same names. but not something way off like a Korg or similar .
But would be important if using a korg key board or module so the names more closely match those.
Also any selection of msb and lsb reqired by the keyboard would be taken care of.
As I say you are only using a generic name gm set so in this case the lsb and msb will always be zero and require no further work.

When we get round to specific models of keyboards or VSTi we will talk about pat files see my post in your other thread. Post 2 and visit my web site link.
And look through some of my other articles on midi and msb lsb etc.
Mike

BIAB2021 UltraPlus,AsusN55S1Tbssd, W10/64,Akai EIEpro
Yamaha CVP405,SquireStrat, CoolsoftVMidSynth
Novatation Impulse61 Ctr kbd, Cwalk blab Kontakt

http://mikesmusic.byethost16.com/