Quote:

Thanks for the input. However, after I configured the mixer the way you suggested, the record audio is still picking up the BIB music. I also cannot hear my vocal in the headphones. If I turn down the FX send on either the channel or the master, both the mic and the music are muted. Any idea what I may be doing wrong?

]


Hi

double check your connections...

Your mic goes into Channel 1. Your computer outputs go into (i think you said) channel 5/6.

The input (lets say left input) of your sound card, is connected to the FX out of the Behringer mixer.

Your headphones are in the behringer mixers headphone input.

You set the FX send level for the vocal, to set the input level for recording on the sound card.

You turn off the FX send level for the channel(s) that the sound card comes into (i think you said 5/6)...this way, no music is being sent to the computer card inputs.....as there is no music being sent along the FX send...just your voice....get me?

you set your monitor level , of your voice and the music you are singing against...by the channel volume knobs....

The FX send, sets the level to be recorded....and the channel volumes set your headphone mix...


remember, that I explained the FX send is POST FADER, so when you adjust the channel knob...you will have a corresponding change in volume on the FX send...so its a couple of quick adjustments...


if you want, I am available now...and I can call you on skype if you like and talk you through it....

cheers

Wiz

skype name wizozland email me at forums AT dodo DOT com DOT au