Keyed,
I've been busy, so I didn't see this thread.

Open Band In A Box.
From the Menu, select Opt/MIDI/Audio Driver Setup window.
Halfway down on the right side, it says Use VST/DXi Synth. Make sure that is checked.
In the drop down below that, it should say VST/DXi Synth Settings...[Cakewalk TTS-1]

That selects your TTS-1 as the output synth.

Click Audio Settings.

The Audio Settings Dialog should open.

Top right hand corner, select MME.

Click the AUdio Drivers button.

Select the device, both in and out, that your speakers are hooked to. I'm sorry I forget what you're using.

Click OK.
Everything else should be left alone for now.

Click OK again. This closes the Audio Settings Window.

Click OK in the MIDI/Audio Drivers Setup window.

Open a song, and play it. You should hear it from the device that you have your speakers hooked up to.

On the Toolbar, there is a button for DXi Synth. Press that, and it should open the DXi synth window and you should see the TTS-1 mixer panel. This only shows you that it is working, and you can adjust the sounds from here as well.

Gary

I'm blessed watching God do what He does best. I've had a few rough years, and I'm still not back to where I want to be, but I'm on the way and things are looking far better now than what they were!