Hi


Originally Posted By: Matt Finley
Howard, is this a RealBand question?

Just to be clear, automation means to me that you use a mixer to record the motion of faders on a mixing console. When you play back the song, the changes in faders are played back too. Are we talking the same thing? BIAB does not support this; it would normally be done in a DAW that uses a control surface.


Yes, but Realband does allow you to enter automation vol nodes after the event to a track.
By drawing them in.
This is what I was assuming was the case here.
Mike


BIAB2021 UltraPlus,AsusN55S1Tbssd, W10/64,Akai EIEpro
Yamaha CVP405,SquireStrat, CoolsoftVMidSynth
Novatation Impulse61 Ctr kbd, Cwalk blab Kontakt

http://mikesmusic.byethost16.com/