1-Right click on start then click on device manager.
2-click on Universal Serial Bus Controller
3-click on any USB hub then click on Power management
4-Make sure the there is no check mark on "Allow the computer to turn off this device to save power" then click OK
5-repeat 3 and 4 for every USB hub on your system.

This will keep the power on to all of your USB hubs, i.e. no more shutting them down.

Note that sometimes a Win 10 update will change them back so you may have to periodically reset them.

Attached Files (Click to download or enlarge) (Only available when you are logged in)
USB power.jpg (296.16 KB, 135 downloads)

I get most of my exercise these days from shaking my head in disbelief.


64 bit Win 10 Pro, the latest BiaB/RB, Roland Octa-Capture audio interface, a ton of software/hardware