I have a request into PG support about this but thought I'd asked if anyone else has seen this. I did a couple of forum searches but didn't locate anything.

Note I've installed the latest build 3 for RB and the issue is still present. Also reset to defaults and the issue is still present.

When using a soft synth there is a Vol Trim box next to the synth name. You can use this to adjust the audio output level of the soft synth. This works fine, expect it's not persisting for me.

That is I load a SEQ file and Vol Trim is at 0. The synth output level is fairly low, so I change Vol Trim to say 7 and that is just about right for my application.

I save the SEQ file and as long as I don't reload the Trim stays at 7. If I reload the SEQ file then Vol Trim is back to 0.

This is specifically with the VSTSynthFont64 sound font player, if that makes any difference.

Is there somewhere else where the Vol Trim level needs to be set so that it is persisted?

Thanks,
Burt