Originally Posted By: Notes Norton
To set your pitch bend range in MIDI, you need to use 3 continuous controllers in succession. I make them one tic apart, but as long as there are no other CCs in between you should be OK.

cc#100=0
CC#101=0
CC#6=total pitch bend range in semitones. I usually enter 2, unless I have a need for more. My old MT32 synth module is set at 12 semitones.
..............


Thanx for bringing this up Notes. I had forgotten about that as I was typing my message.


Life is short so make sure you spend as much time as possible on the Internet arguing with strangers.

64 bit Win 10 Pro, the latest BiaB/RB, Roland Octa-Capture audio interface, a ton of software/hardware