I do not know where the instructions are, too tired to search the manual. Had a couple loooong days.

But in my image below you can use the Port setting in the right-click menu to route tracks to a specific Master Out subgroup.
On my system the labeling now appears wonky (in the image below) .. but the long/short of it is use the Port option to assign an output.
It appears you can have about 16 Ports, but I only have a couple enabled most of the time.
/These ports/paths must be enabled in Prefs-Audio-Drivers area before they'll show up in the Track Port list, which makes sense .. but again I feel like I had to figure a lot of this stuff out due to sparse documentation.
//it's all my fault, I know

Attached Files (Click to download or enlarge) (Only available when you are logged in)
RB_Subs_port.jpg (55.78 KB, 88 downloads)
Last edited by rharv; 03/07/24 04:55 PM.
I do not work here, but the benefits are still awesome
Make your sound your own!