Hi Scott.

I've had a look and it seems that the capo information is not automatically added to the lead sheet. This information could be written on the lead sheet after it is printed. There are also a couple of ways of adding this information in BIAB. The easiest would be using "Section Text" layer and enter the information in that layer at Bar 1. This prints on the lead sheet.

I have used the Standard View mode to access this. If you are in Full Screen view, you can use CTRL+T to switch between views.

[Linked Image - Only viewable when logged in]

This can be seen on the lead sheet below.

[Linked Image - Only viewable when logged in]

Regards,
--Noel


MY SONGS...
Audiophile BIAB 2025