+1/ exactly

My latest experience is now when testing out the new stem separation in BIAB 2025.

Stem separation was fairly easy and straight forward as such but then when it comes to use it in BIAB to generate music against it I need to make a Time Map with ACW.

I have managed to do this before at times after spending hours on it and looking through the manual and guidance from the forum.
But this knowledge is nothing that sticks or that I remember now since I don’t use ACW in BIAB unless I really have to (and I don’t since I do most of my work outside BIAB in my DAW and other software).

So I tried to do the Time Mapping in ACW once again but gave up after one hour.
I just don’t want to spend any more time on it (it is done automatically or by one single operation in other software).
I know that I can figure it out again if I go back to my notes and check the guidance notes here on the forum but that will again take hours and I don’t want to be there.

The above is given just as an example.
The new stem separation seems to work fine but falls more or less flat since the next step in the workflow - to set the time map - is very frustrating and time consuming (at least for for me).