Previous Thread
Index
Next Thread
Print Thread
Go To
#218817 10/22/13 11:09 AM
Recording, Mixing, Performance and Production
Joined: Jan 2006
Posts: 604
S
Journeyman
OP Offline
Journeyman
S
Joined: Jan 2006
Posts: 604
We have recorded our rehearsal on a Zoom R16 and occasional I hear some distortion on the rhythm track, doesn't seem like peak clipping when I zoom in on the wave file. Any idea where to look?

Listen here: https://soundcloud.com/kierbye1/rhythm-0-wav

Strat

Recording, Mixing, Performance and Production
Joined: May 2000
Posts: 38,502
M
Mac Offline
Veteran
Offline
Veteran
M
Joined: May 2000
Posts: 38,502
It might be due to analog clipping/overload in the stages before digitization or in the A to D chip. You may not be able to see clipping from that stage in the digital waveform view, since the digital wave is not being clipped.

If there is a mic PAD on the unit, try turning that down.

If no Pad control, try moving the mics further back from the sound source and see if it clears up.

If the mics on the unit have plugs to connect, the plugs could need some cleaning due to oxidation at the connection points. Deoxit or equivalent on a pad and wipe the plugs with it, insert immediately a few times to get the good goo inside the jack as well.


--Mac

Recording, Mixing, Performance and Production
Joined: Jan 2002
Posts: 7,913
R
Veteran
Offline
Veteran
R
Joined: Jan 2002
Posts: 7,913
Sounds like it's from a Strat - correct?

I've experienced static electricity build-up on the Made in Mexico strat that I used to own and I solved it by backing the pickguard with copper foil, when I also shielded the pickup cavities with copper foil.

That sounds a bit like it, from what I remember back in the day. That was a little under 10 years ago when I bought that guitar and had the disappointing static build up and release, ruining some recordings.

Does it always sound like the very short snippet you posted, or does it change at all over time? Mac eludes to the whole signal chain. What exactly is the full signal chain from guitarist-->guitar-->....-->ZoomR16?

Also is that clip that you posted a .wav rendering from the guitar channel alone or is it from the Zoom R16 output mix-down of all of the tracks? I ask this because it also sounds a bit like an open cable that got recorded accidentally.

Recording, Mixing, Performance and Production
Joined: Jan 2006
Posts: 604
S
Journeyman
OP Offline
Journeyman
S
Joined: Jan 2006
Posts: 604
Interesting! The guitar is a newly bought U.S. tele. I'll try to describe the signal chain to you soon.
the track is recorded from a shure (dynamic) mike in front of the amp, we have used this setup many times without any anomaly. I'm attaching a longer version of the rhythm track where the distortion is heard here and there. I'm eagerly awaiting your comment :-)


https://soundcloud.com/kierbye1/rhythm-1-wav

Strat

Recording, Mixing, Performance and Production
Joined: Jan 2002
Posts: 7,913
R
Veteran
Offline
Veteran
R
Joined: Jan 2002
Posts: 7,913
I heard it right near the end as the only other point where it was evident. It's really impossible to tell which part of the signal chain this is coming from: guitar--->effects loop perhaps-->amp
or
mic-->direct box perhaps-->zoomR16

I'm afraid without being on-site to diagnose and debug, I won't be of much help. It certainly doesn't appear or sound to be overdriving of the mic, nor clipping of the input stage on the Zoom unit. This sounds like a static build-up/release issue to me.

-Scott

Recording, Mixing, Performance and Production
Joined: Jan 2006
Posts: 604
S
Journeyman
OP Offline
Journeyman
S
Joined: Jan 2006
Posts: 604
I hear it at 0.11, at 0.15 (harsh) 0.22, 0.27, 0.43 and at 0.47 (harsh), can you hear the same Scott?

Strat

Recording, Mixing, Performance and Production
Joined: May 2000
Posts: 38,502
M
Mac Offline
Veteran
Offline
Veteran
M
Joined: May 2000
Posts: 38,502
If you did not notice that distortion "in the air" while recording, but only heard it at playback of the recording, Scott's theory is shot.

I assumed that you are savvy enough to have heard anything that sounds like that coming from the guitars and etc. while actually playing, and would have stopped to correct it or at least check it out.


--Mac

Mac #218952 10/23/13 02:05 PM
Recording, Mixing, Performance and Production
Joined: Jan 2006
Posts: 604
S
Journeyman
OP Offline
Journeyman
S
Joined: Jan 2006
Posts: 604
I must shamefully admit that it was first when I was trying to add a Little audio cosmetics to the rhythm track that I became aware of the distortion. It is something that has come up during the last two rehearsals and the reason I haven't noticed it while we were all playing is two fold. We play (too) loud and the distortion is intermittent, on some takes it's not there at all?

Strat

Recording, Mixing, Performance and Production
Joined: May 2000
Posts: 38,502
M
Mac Offline
Veteran
Offline
Veteran
M
Joined: May 2000
Posts: 38,502
Originally Posted By: stratocaster
...We play (too) loud and the distortion is intermittent, on some takes it's not there at all?

Strat


That comment supports what I said above in my first answer.

Try the things I suggest up there.

The offending areas do indeed have a sound I've heard before, that is, the analog electronics being pushed into distortions before or in the A to D circuitry.


--Mac

Recording, Mixing, Performance and Production
Joined: Jan 2002
Posts: 7,913
R
Veteran
Offline
Veteran
R
Joined: Jan 2002
Posts: 7,913
I hope you are able to find the issue. I would think that this sound could be hard to hear in a rock band rehearsal unless you are specifically listening for it. I assume you are close-micing the amplifier because the drums and so forth are so far down in level on the sample you posted.

Something unintentional is certainly going on. The intermittent nature and appearance in the track where its not actually the hot section of the signal is going to make it hard to track down. Time to see if you can isolate it without the pressure of a rehearsal going on, in my opinion.

Recording, Mixing, Performance and Production
Joined: Jan 2006
Posts: 604
S
Journeyman
OP Offline
Journeyman
S
Joined: Jan 2006
Posts: 604
Thanks all for your suggestions, I sure hope to find out what's going on. I remember back in the day when a transmitting CB radio nearby could breake into the amps circuitry and generate all kinds of strange sounds, but I guess that's not what's going on here :-)


Strat

Previous Thread
Next Thread
Go To

Link Copied to Clipboard
ChatPG

Ask sales and support questions about Band-in-a-Box using natural language.

ChatPG's knowledge base includes the full Band-in-a-Box User Manual and sales information from the website.

PG Music News
Band-in-a-Box 2025 Italian Version is Here!

Cari amici
È stata aggerate la versione in Italiano del programma più amato dagli appassionati di musica, il nostro Band-in-a-Box.
Questo è il link alla nuova versione 2025.

Di seguito i link per scaricare il pacchetti di lingua italiana aggiornati per Band-in-a-Box e RealBand, anche per chi avesse già comprato la nuova versione in inglese.

Band-in-a-Box 2025 - Italiano
RealBand 2025 - Italiano

Band-in-a-Box 2025 French Version is Here!

Bonjour à tous,

Band-in-a-Box® 2025 pour Windows est disponible en Français.
Le téléchargement se fait à partir du site PG Music

Pour ceux qui auraient déjà acheté la version 2025 de Band-in-a-Box (et qui donc ont une version anglaise), il est possible de "franciser" cette version avec les patchs suivants:

BIAB 2025 - francisation
RealBand 2025 - francisation

Voilà, enjoy!

Band-in-a-Box 2025 German Version is Here!

Band-in-a-Box 2025 für Windows Deutsch ist verfügbar!

Die deutsche Version Band-in-a-Box® 2025 für Windows ist ab sofort verfügbar!

Alle die bereits die englische Version von Band-in-a-Box und RealBand 2024 installiert haben, finden hier die Installationsdateien für das Sprachenupdate:

https://nn.pgmusic.com/pgfiles/languagesupport/deutsch2025.exe
https://nn.pgmusic.com/pgfiles/languagesupport/deutsch2025RB.exe

Update Your Band-in-a-Box® 2025 to Build 1128 for Windows Today!

Already using Band-in-a-Box 2025 for Windows®? Download Build 1128 now from our Support Page to enjoy the latest enhancements and improvements from our team.

Stay up to date—get the latest update now!

Update to RealBand® 2025 Build 5 Windows Today!

Already using RealBand® 2025 for Windows®? Download Build 5 now from our Support Page to ensure you have the latest enhancements and improvements from our team.

Get the latest update today!

PowerTracks Pro Audio 2025 for Windows is Here!

PowerTracks Pro Audio 2025 is here! This new version introduces many features, including VST3 support, the ability to load or import a .FLAC file, a reset option for track height in the Tracks window, a taller Timeline on the Notation window toolbar, new freeze buttons in the Tracks window, three toolbar modes (two rows, single row, and none), the improved Select Patch dialog with text-based search and numeric patch display, a new button in the DirectX/VST window to copy an effects group, and more!

First-time packages start at only $49. Already a PowerTracks Pro Audio user? Upgrade for as little as $29!

www.pgmusic.com/powertracks.htm

Video: Summary of the New Band-in-a-Box® App for iOS®

Join Tobin as he takes you on a tour of the new Band-in-a-Box® app for iOS®! Designed for musicians, singer-songwriters, and educators, this powerful tool lets you create, play, and transfer songs effortlessly on your iPhone® or iPad®—anytime, anywhere.

Band-in-a-Box® for iOS® :Summary video.

Check out the forum post for more information.

Forum Statistics
Forums58
Topics84,063
Posts774,254
Members39,543
Most Online25,754
Jan 24th, 2025
Newest Members
ghodrat, Patrenotes, ericpete001, wsmart54, Axel1986
39,542 Registered Users
Top Posters(30 Days)
MarioD 199
DC Ron 113
rsdean 98
Noel96 92
WaoBand 76
dcuny 68
Today's Birthdays
annick.vanlooy, Ray George, Timber
Powered by UBB.threads™ PHP Forum Software 7.7.5