Well… Now I’ve done it. I had a bit of a problem with my computer this morning and ended up having to re-install BIAB and RB. No big deal, right? Wrong. I can’t get RB to play… no MIDI sounds coming out. I don’t understand it… when I first got the SD2 it was so easy to install…

I have the M-Audio USB MIDI interface. And yes… I have the plugs in the right “IN” and “OUT” sockets. The RCA plugs come out from the back of the SD2 into my Audigy 2. In fact, I didn’t even remove any of the wires so they’re all in the same places as they have been all along.

I have the MIDI driver setup pointing to USB UNO in and USB UNO out. I have checked the Audigy mixer… the input where I have the SD2 plugged in is open. I checked Windows… MIDI playback is set to USB UNO MIDI OUT. All of the volumes are up in both the Audigy and Windows mixers. When I play a song, the SD2 is flashing, meaning that MIDI is going into it. But it doesn’t come out.

I made sure that I had the latest M-Audio drivers for the interface - the same setup as I had before this problem.

The only way I can get any MIDI sounds to come out is if I select "SB Audigy Synth A" for the output driver. Needless to say this isn’t what I want.

I went way back in the forum looking for old posts that I might have made about this… but the only post that refers to the SD2 is the one I made, telling everyone that I got a new SD2 and how much I loved it. This is what I can’t understand… it installed so easy when I got it… what’s wrong now?

Much appreciated…
Bobby

https://soundcloud.com/bobby-t-394727974