Bobby,
Two things.

First, of course, you need to have the Audigy selected in the Audio Setup dialog for RB. Make sure the input you have selected is selected and highlighted on the list.

SOMETIMES, RB and PTW will not put the input you are using at the TOP of the list. RB and PowerTracks ALWAYS use the input at the top of the list. So, when you click to make the track and AUDIO track, make sure that it is using the correct input.

For instance, if the Wave is listed as the top Input in the Audio Setup, then every time you create an Audio Track to record, it's going to record from the Wave input, which means the Wave output. So, if you have your mixer plugged into the Line In 2 input on the Audigy, you MUST select Line In 2 as the Audio Input device. This is on the Track, not the audio config dialog. With the Audigy you have, you have several different inputs, make sure you're using the one selected.

If you do, make sure the outputs of the mixer are going to the right place, if you're using a condensor mic, make sure the Phantom power is turned on, and read the manual for the mixer to make sure that you've set up the input gain for the mic correctly. You want to see movement on the mixer VU meter for when you sing, even before you get to the sound card or Real Band.

Gary

I'm blessed watching God do what He does best. I've had a few rough years, and I'm still not back to where I want to be, but I'm on the way and things are looking far better now than what they were!