Well... I did it again... wasted a whole lot of time pulling my hair out and wasted your time answering my questions for the second time. I have to start reading what is told to me completely and more than once. Gary, you sent me the answer to this question BEFORE I even got the mixer. When it got here I was in such a hurry to get it up and running, I only read the top part, couldn't get it to work, posted another question (the same one, in a way) and then FINALLY sat down with the FIRST response you gave me and read the WHOLE thing 3 or 4 times... and found the answer. So sorry - I'll try not to let it happen again.

But... here's something that isn't in the response; After I've recorded all my tracks into audio, they play nicely through the speakers like you said they would. But you suggested that I run these audio sounds into the mixer so that I can monitor them through my headphones. Problem is, I don't have any outputs on the Audigy to run it back into the CD/Tape In. I connect my power speakers through the optical output. Is it possible to also have it send out through the Speaker Out on the back of the card at the same time? I've tried it but haven't had any success so far. I have the headphone jack on the card but I don't think I should be using that, right? I have the S/PDIF output but I don't think that's an option either, right? I'm so close... maybe a little more of your helpful input would get me over the top??? It sure would be appreciated.

Bobby

https://soundcloud.com/bobby-t-394727974