Originally Posted By: Rich59
This is going to sound like a really dumb question but I will not get an answer if I do not ask.

I recorded mono tracks from my line 6 podxt into my Tascam interface. One went to the left , the other to the right. If I try to pan them to the opposite side the signal disappears. I would not normally do that but if I wanted to change the mix in such a way as to say bring both guitars to the right side I can not do it in real band. I always thought a mono signal can be panned anywhere in the plain.
Thanks Rich




Hey Rich. There are no dumb questions.


"I recorded mono tracks from my line 6 podxt into my Tascam interface. One went to the left , the other to the right."

Not enough information. After the Tascam, where did you actually 'record' the mono tracks? If you set your panning full counterclockwise (left) you were only recording on the left channel. Did you set up the tracks to record in stereo?

Quick fix is no big deal. Just bounce the mono track to a stereo track. Faux Stereo, to be sure, but it can save a lot of time.

Regards,

Bob

Dyslectics Untie!


https://90dbband.bandcamp.com/

https://soundcloud.com/90-db

https://www.youtube.com/channel/UCm_3mpivKYV7T7XFJmXL-GA