Hi Rich

My guess is that you are saving as a midi file as you were working in midi,

Unfortunately midi does not save track information only channel and voice and midi data etc
In order to save track specific information like assigned synth you must save in the DAWS native format .
For Realband that is a . SEQ file , it will then recall those setting when loaded.
If you save or export as midi you will always have to tell the receiving program what synth it is using on what track so if for example you save as midi then open in say Sona you would have to reassign your specific synths vst etc to the respective tracks
And then save as a Sona project.
I did explain this on my long link on the other thread
Regards
Mike
ps
Just another point
Midi tracks, midi channels, and midi ports are three separate things ,
Therefore midi channel 2 may not be on midi track2 unless you set it to be.
In fact BIAB uses track 2 for midi drums on channel 10
This again was covered in my link.



Last edited by Mike Head; 04/05/18 01:16 PM.
BIAB2021 UltraPlus,AsusN55S1Tbssd, W10/64,Akai EIEpro
Yamaha CVP405,SquireStrat, CoolsoftVMidSynth
Novatation Impulse61 Ctr kbd, Cwalk blab Kontakt

http://mikesmusic.byethost16.com/