After downloading 2022(905) I tried the new version on AVL:MXE Linux again.

The download managers doesn't run, but as I have the same drive mounted on both Linux and Win10, 2022(905) was already installed under Windows, so was there to run.

I ran both 64-bit and 32-bit successful, though they were again un-activated. This time I tried activation the 32-bit version and did so successfully. I'd hoped activating that version instead of the 64-bit version might have allowed the latter to work properly, but it did not, again getting a Wine program error. There are no details withing the pop-up "Details" tab.

I tried running from a command line and saw the following, which may give a clue:

wine: Unhandled page fault on read access to 000000007BF7F6BA at address 000000000118896A (thread 0244), starting debugger...

It didn't actually successfully use a debugger (I may not have one ... maybe I should install something.) It's possible this fail may indicate a page issue in the Windows application, though whether it's findable from the above I know not. It's very likely there are no symbols in the shipped binary, so me trying to debug is probably a lost cause.

The subsequent message were all of the form:
0254:fixme:dbghelp:elf_search_auxv can't find symbol in module
which may also indicate no symbols.

The 32-bit version seems to run OK and at present most VSTs still have 32-bit versions, so it's likely usable for some time yet.

Jazz relative beginner, starting at a much older age than was helpful.
AVL:MXE Linux; Windows 11
BIAB2025 Audiophile, a bunch of other software.
Kawai MP6, Ui24R, Focusrite Saffire Pro40 and Scarletts
.